This braided airhose is constructed for durability. Its brightly covered braid over plastic tuning makes it the ideal air hose for use with all Paasche airbrushes. Couplings are sealed at the factory for safety and to prevent leaks. Maximum working pressure is 100 P.S.I. 10 feet in length

This braided airhose is constructed for durability. Its brightly covered braid over plastic tuning makes it the ideal air hose for use with all Paasche airbrushes. Couplings are sealed at the factory for safety and to prevent leaks. Maximum working pressure is 100 P.S.I. 20 feet in length

This braided airhose is constructed for durability. Its brightly covered braid over plastic tuning makes it the ideal air hose for use with all Paasche airbrushes. Couplings are sealed at the factory for safety and to prevent leaks. Maximum working pressure is 100 P.S.I.

The attached Moisture Trap is a 2" long unit that removes water from the airline thus preventing moisture damage and inconvenience. 10 foot in length.

This small 2" long Moisture Trap (MT) unit removes water from the airline thus preventing moisture damage and inconvenience. Can be installed on any 1/8 inch I.D. air hose.

Used in conjunction with the Paasche No.2 and No.17 Air Propellant cans to control the air volume from the can to the airbrush.

The R-75 is an in-line low pressure regulator with a 60 p.s.i. gauge and moisture drain. This regulator gives user control of operating pressure as well as assisting in furnishing clean, dry and regulated air. Regulators must only be used as instructions and warnings specify. Five (5) micron filtration, 15 SCFM @ 50 p.s.i.

CAUTION: R-75 is not for use on LCT Tanks.